Solar LED outdoor decoration Light - RG-CK-02

solar string lights

1. Parts contained
a. Solar panel with LED strand : 1pc
b. Ground tube : 1pc
c. Pointed ground stake : 1pc
d. Wall bracket : 1pc
e. Screw and drywall anchor : 2 sets

2. Installation
Solar light must be installed in a sunny location where it can receive
maximum sunlight during daytime hours. Any cover that shades the solar
panel will affect its ability to absorb sunlight and decrease the amount of
brightness and duration of the LED lights and its function will be decreased.
The selected location should not be near a nighttime light source such as a
porch light, street light, etc as these lights might prevent the solar rope light
from automatically turning on.
The electronic box can be positioned in the ground with the tube ad pointed
stake or on a flat surface with the wall mounting bracket. Always place the
tube or wall mounting bracket first, then attach the electronic box. Be sure the
solar panel is pointed toward the light.

3. Operation
Charge battery for at least 8 hours before first use. Turn power switch to the
ON position and the selection switch to the AUTO position when first
activated. NOTE : THE UNIT WILL NOT FUNCTION IF « MODE » IS
SELECTED WHEN FIRST ACTIVATED.
a. AUTO
Turning selection switch to the AUTO position will cycle the lights
through seven different flashing sequences : 1. Steady on, 2. Fast
twinkling, 3. Slow twinkling, 4. Slow flashing in series, 5. Slow
flashing in reverse series, 6. Fast flashing in series, 7. Slow flashing in
series followed by reverse series. Each sequence will last for
approximately 10 seconds.
b. MODE
The user can select any of the above sequence for constant use. While
in the AUTO position, turn the select switch to the MODE position
when the desired sequence is illuminated. The light will continue to
operate in the selected mode until the unit is either turned off or another
sequence is chosen.

4. Battery changing
If your lights should begin to illuminate dimly or for shorter durations of
time, you should replace the rechargeble batteries in the following way : 1.
Unscrew 4 screws and remove bottom plate from the electronic box, 2.
Replace the old batteries with new one.

Warning : 1. Be sure that battery polarity and voltage are correct (wrong polarity is
dangerous), 2. Do not dispose of old batteries, they should be recycled.