Waterproof,LED chrismas light,LED string light 10M 100LED - GL-0001

led christmas shower light

Assembly Information:

1. Solder connection should only be performed on designated solder pads (marked “ +/-”). During soldering, don’t exceed the maximum soldering time of 10 seconds and the maximum soldering temperature of 260 celsius degrees.

2. The smallest unit (3 LEDs) can be removed by cutting with scissors between the designated solder pads.

3 .The mounting of the strip is facilitated by means of the double-sided adhesive on the back-surface of the strip. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt partied. The mounting substrate must have sufficient structural integrity. Take care to completely remove the adhesive backing. Once the strip is appropriately positioned, press on the strip with about 20N/cm2 (refer to application techniques of 3M adhesive transfer tapes).

4. The minimum bending radius is 2 cm. The strip may be bent over a smaller radius of the circuit board containing no electronic components and such bends should be made once and fixed in position to avoid cyclic fatigue.