UV-TEC T5 electronic ballast for uv lamp 25W-40W - INN-425-40B

INN-425-40B

Lamp Type: GPH793T5 GPH843T5 G36T5

TUV36T5 TUV36W TUV PL-L36W

Wiring Diag:A

Lamp Type:GPH212T5 GPH287T5 GPH357T5 GPH436T5

TUV11W TUV16W

Wiring Diag:B

Technical Specifications

AC source:198~264V

Mains Frequency:50/60HZ

Power Factor:>0.90typ

Efficiency:>85%typ

Operating Frequency:30-50KHZ

Dimensions:165x38x26mm

Input LIne Length:430mm

Output Line Length:480mm

Signal Line Length:480mm

Installation Requirement

LED specification:VF=1.8-3.6V IF=5-20mA

Max.cable lengthbetween the ballast and the lamp :1.5m

Mounting Restrictions

Disconnect input power before installing or servicing

ballast case must be grounded

Don't short any two wires for indoor use only

Features

electronic ballast for one or two lamp operation

to be used with four-wire lamps

instant start

lamp status indication via DC signal output(connected LED requirement)

DC 5V ± 5%(5mA):lamp on

DC 0V :lamp fault or no lamp

For applications with less than one switch-on cycle per day(otherwise

preheat start ballasts are recommended)

Applications

All areas of applications include UV lamps:

=> Air Purification

=> Aquairum

=> Industrial water treatment