12V 66W electronic ballast, 3 YEARS WARRANTY hydroponics - LVXX66/-S,LV

1.Wide input voltage range, 2.Embedded technical grade MCU, 3.Double loop control, 4.3 years warranty - details see: https://www.lightinghere.com/12v-66w-electronic-ballast-3-years-warranty-hydroponics-10000492
Place of Origin: Anhui China (Mainland)Brand Name: JNModel Number: LVXX66/-S,LVStyle: Electronic
Usage: Low pressure sodiumMatched Tube: 54Power Factor Compensation: Activecolor: black
size: 18.7*7.6*5.8   
12V 66W electronic ballast, 3 YEARS WARRANTY hydroponics
contact supplier for 12V 66W electronic ballast, 3 YEARS WARRANTY hydroponics


MAIN FUNCTIONS AND CHARACTERISTICS:

1.Wide input voltage range; compatible with systems of different capacity; temperature compensation function

2.Low current coefficient, 99% symmetrical output wave

3.Embedded technical grade MCU, intellectual control

4.Double loop control, constant output power

5.Complete protection: open circuit, under/over voltage, over current, input reverse

6.Adopting frequency conversion technique and PWM&PFM hybrid control to get rid of acoustic resonance

7.Particular ignition circuit, intellectual ignition function

8.Up to 20m of wire be connected to output, easy installation and maintenance

9.Excellent cooling effect, operating temperature up to 50°C

INSTALLATION AND USE: Please install the system following the diagram underside (pay attention to the positive and negative polarity). First install the lamp, then the battery, at last the solar panel. There are 4 LED to display the charging stateand capacity. To avoid the interference, there are 10 seconds before the protection and recovery of under voltage, while there is no delay before over voltage protection.

Time Set: The light/time control works as following: light on as sunset →light off as the first timer overflow→light on as the second timer overflow→lighting off as sunrise. Press the SET button and the on-time setting will be activated. The 4 LED mean 8, 4, 2 and 1 from top to bottom. Adding the numbers behaved by the lighting LED together will produce the on-time for the load lamp. Based on this, each press will increase the on-time by 1 hour. The maximum on-time will be 15 hours. After finishing setting the on-time, wait for 5 seconds and the off-time setting will be then activated. Here, the top two LED and the bottom two LED will light alternately. Operate as the method above to set. At last the time setting will be valid after 5 second of no operation.

Notice:

1.Check the voltage and capacity of system before installation.

2.Pay attention to high voltage isolation when installing the lamp. Ensure the polarity of positive and negative is not reversdwhen installing the batteries and the solar panels.

3.Please use the 5KV cable whose sectional area is larger than 0.5mm2 to connect ballast with lamp! It’s dangerous to touch the output terminal with high voltage. Better cover the cable with cotton varnished sleeve.

4.If solar panel is reversed, just correct it and the product will work normally. If the battery is reversed, the fuse will blowPlease replace it. The accessory is the fuse. The specification of the fuse used by integrated machine is 15A, ballast is 10A

5. Please forgive it if this document is a little different from the product for the sake of upgrading!

Packaging Detail:As per schedule
Delivery Detail:As per schedule

Related Product for 12V 66W electronic ballast, 3 YEARS WARRANTY hydroponics